UP27I and UP27E SERIESINTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE AND OPERATION INFORMATION
- 10 -8. PREPARE THE HOOD (CONT’D)8.1 UP27I SERIES RANGE HOOD (INTERNAL BLOWER) (CONT’D)HORIZONTAL DISCHARGE (DUCTED INSTALLATION ONLY)(CONT’D)Using 3
- 11 -10.INSTALL THE HOODPlace the hood at its location. Using a pen, mark the position of the screw (smaller part of the keyholes [A]). Remove the ho
Reinstall the grease drip rail.13.REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS13.1 DUCTED INSTALLATION:Reinstall Evolutionary™ hybrid baffle filters
- 13 -15.USE AND CAREEvolutionary™ Hybrid Baffle FiltersThe Evolutionary™ hybrid baffle filters should be cleaned frequently. Use a warm detergent sol
- 14 -16.OPERATION (CONT’D)HEAT SENTRYBoth UP27I and UP27E series are equipped with a HEAT SENTRY thermostat. • If blower is ON at a lower speed setti
- 15 -SERVICE PARTSKEY PART QTY (HOOD WIDTH)NO. NUMBER DESCRIPTION 30’’ 36’’ 42’’ 481 V14971 ADAPTER/DAMPER 3¼” X 14” 1 1 1 12 T461 ADAPTER/DAMPER 3¼”
- 16 -SERVICE PARTSKEY PART QTY (HOOD WIDTH)NO. NUMBER DESCRIPTION 30’’ 36’’ 42’’ 48’’1 V13923 FEMALE CONNECTOR 11112 V13924 MALE CONNECTOR 11113 V034
WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended
HL0086- 3 -Model 415(7” roundadjustableelbow,optional)Model 4188” roundadjustableelbow,(optional)UP27I SERIESHOOD(Canopy with internalblower, controls
- 4 -HL0087- UP27E SERIES RANGE HOOD SYSTEM -IN-LINE AND EXTERIOR BLOWERSIn-line and exterior blower rough-in kit(included with EB6, EB9, EB12, EB15,I
- 5 -1. SELECT BLOWER OPTION AND INSTALLATION TYPE1.2 DUCTED INSTALLATIONEither UP27I or UP27E Series range hoods may be ducted. For a UP27E Series ra
Remove the installation kit from inside the hood.Make sure that the following items are included:- Installation manual- Adapter/damper 3¼” x 14” to
- 7 -7. PREPARE THE CABINETFor cabinets with recessed bottom, attach two wood filler strips cut to length (not included), on each side, as shown below
- 8 -7. PREPARE THE CABINET (CONT’D)7.1 DUCTED INSTALLATION:Cut-out the openings for duct (A) and house wiring (120 V AC)(B) according to the directio
- 9 -HORIZONTAL DISCHARGE (DUCTED INSTALLATION ONLY)The UP27I Series range hoods are factory set to exhaust vertically. If the horizontal discharge is
Commentaires sur ces manuels