Best WPP9IQT42SB Manuel d'installation télécharger pdf (Page 12)

- 12 -

WIRING (WPP9IQ and WPP9IQT)

Note: This range hood must be properly

grounded. The unit should be installed by a

qualified electrician in accordance with all

applicable national and local electrical codes.

1. Remove the wiring box cover. Remove a

knockout from the wiring box (Fig.10).

2. Secure the conduit to the wiring box through a

conduit connector.

3. Make electrical connections. Connect white to

white, black to black and green to green.

4. Replace wiring box cover and screws. Make sure

that wires are not pinched between cover and

box.

ADDITIONAL EXTERNAL

BLOWER WIRING (WPP9E)

1. Run 2-wire plus ground power cable from the

exterior blower to the hood’s wiring box marked

“motor connection” (Fig.11).

2. Remove the cover from the wiring box and

remove one knockout.

3. Feed 6” of cable through the knockout opening

and secure the cable to the wiring box with an

appropriate connector.

4. Make electrical connections at the hood.

Connect white-to-white, red-to-black and

green-to-ground.

5. Replace the wiring box cover and screws.

Make sure wires are not pinched between the

cover and box.

Exterior blower connection:

1. Make electrical connections at the exterior

blower (see instructions provided with the

exterior blower).

WIRING BOX

COVER

EXTERIOR BLOWER

BLOWER CONNECTION AT HOOD

BOX MARKED

“MOTOR

CONNECTION”

CONNECT:

WHITE-TO-WHITE,

RED-TO-BLACK,

GREEN-TO-GROUND.

FIG.11

FIG.10

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 71 72

Commentaires sur ces manuels

Pas de commentaire