Best WPP9IQT42SB Manuel d'installation télécharger pdf (Page 13)

- 13 -

MOUNTING SCREWS

(4,8x38mm)

MOUNTING SCREWS

(3,9x9,5mm Pan Head)

INSTALL FLUE MOUNTING

BRACKET

DUCTED AND NON-DUCTED

1.Assemble the flue mounting bracket,

adjusting outside width as shown. (Fig.12)

2.Carefully center the mounting bracket directly

over the range hood location.

3.Secure the bracket assembly to the ceiling

using (2) 4.8 x 38mm mounting screws and

drywall anchors (Fig.13). Make sure the

bracket is pushed into the corner, tight against

the wall if necessary, and centered over the

hood. Complete the installation.

DUCTED INSTALLATION ONLY

Note: Rooms with 10 or 11 foot ceilings

require flue extension model AEWPP9SB,

available from your local dealer. Discard

the upper flue supplied with the range

hood and replace it with the longer flue

extension.

1. Attach ductwork to damper/duct connector.

2. Run 8” WPPIQ or 10” WPPIQT & WPPE

diameter metal ductwork to the outside

location (Fig.14).

3. Install an appropriate wall or roof cap with

damper to exhaust the air to the outside.

4. Tape all duct joints with aluminum duct tape.

5. Install upper and lower decorative flues

onto the range hood. Vents are concealed

on 8-foot ceilings. Vents maybe exposed

on 9-foot ceilings (Fig.15).

6. Secure upper flue to flue mounting bracket

with (2) 3.9 x 6mm screws (Fig.16).

8" or 10” ROUND

METAL DUCT

DECORATIVE

FLUE

DUCT TAPE

CEILING

CONCEALED

VENTS

DRYWALL

ANCHORS

FIG. 12

FIG. 13

FIG. 14

FIG. 15 FIG. 16

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Commentaires sur ces manuels

Pas de commentaire