Best IP29M Series Manuel d'installation télécharger pdf (Page 10)

- 10 -

15. INSTALL THE HOOD

15.1INSTALLATION WITH DECORATIVE FLUE COVER AEIP SERIES

Assemble the hood assembly to the mounting brackets by aligning keyholes with

4 nuts previously installed in step 8 (2 nuts per side). While holding the hood,

remove one nut and install a washer (included in parts bag) on each pem

stud, then reinstall the nut and tighten it. See illustration beside.

15.2INSTALLATION WITH DRY WALL TRIM ATDIP SERIES

Align hood keyholes with pem studs on brackets. Secure the hood to the brackets

using washers and nuts (included in parts bag). See illustration beside.

14. MOUNT THE DECORATIVE FLUE COVER OR THE DRY WALL TRIM ON THE HOOD

14.1INSTALLATION WITH DECORATIVE FLUE COVER

AEIP SERIES

Remove the protective plastic film covering the decorative flue

cover AEWP Series. Assemble the flue cover on top of hood

using (14) no. 8 x 3/8” screws (provided with decorative flue

cover). See illustration beside to locate mounting screws from

top of hood.

NOTE: Ensure edges fit perfectly before tightening completely

the mounting screws.

14.2INSTALLATION WITH DRY WALL TRIM ATDIP SERIES

Remove the protective plastic film covering the dry wall trim

ATDPI Series. Assemble the dry wall trim on the top of the

hood using (14) no. 8 x 3/8” screws (provided with dry wall

trim). See illustration beside to locate mounting screws from

top of hood.

NOTE: Ensure edges fit perfectly before tightening completely

the mounting screws.

WARNING

The decorative flue cover AEIP Series and the dry wall trim ATDIP Series may have sharp edges. Be careful when

handling and installing these metal parts.

HD0233

MOUNTING SCREWS LOCATION

13. FINISH THE DRYWALL BOX (INSTALLATION WITH DRY WALL TRIM ATDIP SERIES ONLY)

Finish the drywall box. Check fitting with dry wall trim before mounting it to the hood.

HD0234

12. CONNECT THE WIRING

Remove wiring cover from rough-in plate and set aside.

Connect BLACK to BLACK, WHITE to WHITE and GREEN or bare wire under GREEN ground screw. Reinstall wiring cover.

WARNING

Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable

codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting

means to prevent power to be switched on accidentally.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Best IP29M Series Manuel d'installation Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Best IP29M Series